Hunter PGP ULTRA Adj Rotor 20mm BSP c/w Blue/Grey Nozzles
  • Hunter PGP ULTRA Adj Rotor 20mm BSP c/w Blue/Grey Nozzles

Features

  • Pressure Rating: 7 Bar, 100 PSI
    (Recommended pressure range 1.7 to 4.5 Bar, 25 to 65 PSI)
  • Radius: 4.9m to 14.0m
  • Connection Type: Female NPT thread
  • Hunter PGP Sprinkler is the world’s leading rotor pop-up sprinkler for residential and light commercial irrigation systems.
    • Radius 4.9m to 14.0m
    • Arc adjustable from 40 degrees to 360 degrees

Advanced Features:

  • Factory-installed rubber cover for safety
  • Through-the-top arc adjustment
  • Comes with complete set of interchangeable nozzles
  • Proven long-life water lubricated gear drive
  • Radius adjustment of up to 25%
  • Hunter Key is required to make any adjustments to sprinkler (Product Code “HK”)
  • Inlet size 20mm

Tips
Arc Adjustments: Adjustable heads are preset to 180 degrees. Sprinklers may be adjusted with water on or off. It is recommended that initial adjustments be made before installation.

  1. Using the palm of your hand, rotate the nozzle turret counter clockwise to the left stop to complete any interrupted rotation cycle
  2. Rotate the nozzle turret clockwise to the right stop. This is the fixed side of the arc. The nozzle turret must be held in this position for arc adjustments. The right stop does not change

To increase the arc

  1. Insert the plastic key end of the Hunter wrench into the adjustment socket (hole with + - symbols)
  2. While holding the nozzle turret at the right stop, turn the wrench clockwise. Each full 360 ̊ turn of the wrench will increase the arc 90 ̊.
  3. Adjust to any arc between 40 ̊ and 360 ̊
  4. The wrench will stop turning, or there will be a ratcheting noise, when the maximum arc of 360 ̊ (full circle) has been reached

To decrease the arc

  1. Insert the plastic key end of the Hunter wrench into the adjustment socket (hole with + - symbols)
  2. While holding the nozzle turret at the right stop, turn the wrench counter-clockwise. Each full 360 ̊ turn of the wrench will decrease the arc 90 ̊.
  3. Adjust to any arc between 40 ̊ and 360 ̊
  4. The wrench will stop turning, or there will be a ratcheting noise, when the minimum arc of 40 ̊ has been reached

Refer YouTube installation videos

 

Hunter PGP Adjustment Video


Write a review

Note: HTML is not translated!
    Bad           Good

Hunter PGP ULTRA Adj Rotor 20mm BSP c/w Blue/Grey Nozzles

  • $39.75

  • Ex GST

Related Products

Hunter Key

Hunter Key

Hunter rotor adjustment key Tips Arc Adjustments: Adjustable heads are preset to 180 degrees. Sp..

$1.30

Twister Elbow 20mm

Twister Elbow 20mm

20mm twister elbow for connecting 15mm inside diameter pipe to pop-up sprinkler 20mm male BSP thre..

$0.88

Hunter Swing Joint 20mm X 20mm BSP

Hunter Swing Joint 20mm X 20mm BSP

Hunter swing joint 20mm BSP thread x 300mm length The Hunter swing joint easily adjusts sprinklers..

$7.20